-
-
Raspberry Pi3
-
Power bank
-
Fan with GPIO pin
-
LED with GPIO pin
-
Switch
-
router
-
MicroUSB-MicroUSB extension wire
-
Modified MicroUSB-USB wire
-
-
-
To check the phone's battery, look at the screen's top right corner battery indicator.
-
-
-
The configuration of the cable connections as illustrated on the left confirms the connection between compartments are intact.
-
Should any of the cable connections are loose or configured incorrectly, try to reattach the cable firmly to its corresponding plug as illustrated.
-
-
-
Make sure the memory card is inserted into the slot located under the Raspberry Pi, as illustrated with an red arrow on the left.
-
If correctly inserted, you should see a flashing green light on the side near the the power input
-
If you don't see this light, or if this light is in another colour, remove the microSD by pushing it in, and then allowing it to move out. Then, reinsert it and check the lights again.
-
Almost done!
Finish Line